SB-F-F150SCR/13TW5 INSTR_SKU# 011297
InstallatIon
d I F F I C u lt Y :
If you choose to perform the installation yourself, it is absolutely vital that
the Stealthbox® be properly mounted to the vehicle according to these
instructions. Failure to mount the enclosure properly presents two problems:
out
oF
I n s t a l l a t I o n G u I d e
for the
1) The sub-bass performance will suffer due to the movement of the enclosure
caused by the force exerted by the woofer(s).
25
SB-F-F150SCR/13TW5
sKu#94460,94461,94462
2008+
2) A loose enclosure presents a serious safety hazard in the event of a collision
or sudden deceleration.
estImated tIme:
1 HouR
s t e P
1
Remove any contents in the backseat area and flip the seat
up. Place the Stealthbox® on the floor under the drivers side
backseat as shown.
Thank you for choosing a JL Audio Stealthbox® for your automotive sound system. With proper
installation, your new vehicle-specific enclosed subwoofer system will deliver years of listening pleasure.
s t e P
2
There are four brackets that need to be installed on the
enclosure, two on each end.
Shown is the end of the enclosure that would be mounted
near the middle of the cab of the truck, at the other end of
the enclosure the brackets are mounted so that the bottom
tabs go under the enclosure.
We strongly recommend that you have your new Stealthbox® installed by your authorized JL Audio
dealer. The installation professionals employed by your dealer have the necessary tools and experience
to disassemble and reassemble your vehicle properly. Also, keep in mind that your warranty coverage
extends to 2 years if your system is installed or approved by your authorized JL Audio dealer. If you
prefer to perform your own installation, please read this installation guide completely
before beginning the process.
The long end of the bracket attaches to the enclosure using
the supplied hardware (see detaIl below). Do not tighten
hardware down at this point, just get it in place.
d e t a I l
STEALTHBOX WALL
MOUNTING BRACKET
LOCK WASHER
HEX BOLT
THREADED INSERT
FLAT WASHER
Continued on Next Page
SB-F-F150SCR/13TW5 INSTR_SKU# 011297
I n C l u d e d H a R d W a R e
s t e P 1 0
Set the enclosure in place and secure the Stealthbox® to the
previously installed Mount Brackets. Once all hardware is in
location and started, go back through all fasteners and
tighten.
4) Custom Mount Bracket
4) 1/4-20 x 1” Hex Head Bolt
4) 3/8-16 x 1 3/4” Hex Head Bolt 4) 3/8” x 1-1/4” Fender Washer
4) 3” x 3” Wax Square
4) 1/4” Flat Washer
4) 3/8” Flat Washer
4) 1/4” Split Lock Washer
4) 3/8” Split Lock Washer
4) 3/8-16 Hex Nut
s P e C I F I C a t I o n s
Enclosure Type: Acoustic Suspension (sealed)
Driver Type: 13TW5
Nominal Impedance: 3Ohms
Continuous Power Handling: 600Watts
P o W e R R e C o m m e n d a t I o n
s t e P 1 1
It will be easier to go under the vehicle to tighten the four
bolts that come through the floor. Make sure to install the
Fender Washers, Split Lock Washers and, Hex Head Nuts as
shown in the detaIl below.
JL Audio recommends high quality amplifiers such as the JL Audio HD750/1, 500/1v2 or G1700. The diagram below
shows the recommended crossover, infrasonic filter and equalizer settings for the HD750/1. If another amplifier is
being used, please reference this illustration and use similar settings on that amplifier.
All JL Audio amplifiers are very versatile audio components. Please consult the owner’s manual for even more
detailed information about installing and tuning your amplifier.
d e t a I l
C o n n e C t I o n s
Using quality power, signal and speaker wire is essential in ensuring the performance of your Stealthbox®.
JL Audio recommends using a 4 AWG power kit such as the XC-PCS4-1B for your Stealthbox® amplifier, other
kits are available should you be using more than one amplifier. Signal wire such as the JL Audio Premium
Audio Interconnect Cables should be used that will provide signal for both channels of the amplifier. JL Audio
reccommends using 12AWG speaker wire for subwoofers such as our XC-BCS12-25.
m I d / H I G H F R e q u e n C Y d R I v e R F I t m e n t
A variety of JL Audio coaxial and component systems will fit in the factory speaker locations of you vehicle.
Front Speaker Size / Location: 5”x 7” / 6”x 8”- Front Doors
Fits JL Audio Models: TR570-CXi, C2-570x, C5-570, C5-570x & ZR570-CSi
s t e P 1 2
Step back and admire your work, flip the rear seat back
down,
Rear Speaker Size / Location: 5”x 7” / 6”x 8”- Rear Door
Fits JL Audio Models: TR570-CXi, C2-570x, C5-570, C5-570x & ZR570-CSi
C o n G R a t u l a t I o n s !
You have completed the installation for this model!
Enjoy your new Stealthbox®!
(954) 443-1100
Please refer to the Power Recommendation section for an
amplifier recommendation and basic set-up help.
All specifications are subject to change without notice. “JL Audio®” and the JL Audio logo, “Stealthbox” and the Stealthbox logo are registered
trademarks of JL Audio, Inc. “Ahead of the Curve”and its respective logo is a trademark of JL Audio, Inc.
JLA-SKU# 011297 07-24-2009
•
Printed in USA
•
©2009 JL Audio, Inc. U.S. PATENTS: #5,734,734 #5,949,898 #6,118,884 #6,229,902 #6,243,479
•
#6,294,959 #6,501,844 #6,496,590 #6,441,685 #5,687,247 #6,219,431 #6,625,292 #D472,891 #D480,709 Other U.S. & Foreign patents pending.
1
0
3
6
9
N
O
R
T
H
C
O
M
M
E
R
C
E
P
A
R
K
W
A
Y
•
M
I
R
A
M
A
R
,
F
L
O
R
I
D
A
•
3
3
0
2
5
•
U
S
A
Page 2 • JL Audio, Inc 2008
|
Ingersoll Rand Heat Pump 650840 XXX B User Manual
iSimple MP3 Player Accessories IS76PRO User Manual
JVC Stereo Receiver RX 5030VBK User Manual
Kambrook Oven KS200 User Manual
Kambrook Slow Cooker KSC320 User Manual
Kathrein Satellite TV System 9986492 User Manual
Kenmore Freezer 20938 User Manual
Kenwood Car Video System LZH 80TJ4 User Manual
Kenwood Coffeemaker CM700 User Manual
KitchenAid Refrigerator W10291426A User Manual